When fixing drywalls, screws are faster to drill in compared to nails. Although they may occasionally pop out, they do so less frequently than nails, making them more efficient.
The shrinking of the wooden studs placed behind the drywall, due to extreme temperature changes causes the popping of screws. Additionally, attaching lumber that's not completely dry when building walls also causes pop outs
because when wood loses moisture, it contracts resulting in a small space between the back surface of the drywall and the stud.
Thirdly, warping of the lumber where the drywall is being attached makes it difficult for the screw to pull the panel tight causing pins to pop out incase the wall shifts or is hit. Screws hold fine if everything stays stable. If the wall is hit, the door rammed or air pressure suddenly goes up, the wallboard bends inward and pushes the screw out.
Application of adhesive onto the studs before drilling screw creates a surface bond, preventing gaps from forming, therefore putting a stop to screw pops. Adhesives minimize the potential for flexing and drooping, and also substantially reduces the number of fasteners required (up to 75% less) by diminishing the need for screws in the center of the board. Moreover, adhesive is not affected by temperature changes or moisture.
- Whenever small holes happen due to pop outs, gather your drywall supplies, and then position an adhering piece of mesh covering the gap. This will stick to the walls without having to be held up.
- Next, glue generously over the mesh and using a putty knife, smooth it out.
- Leave it to dry completely and then spread the next coating over the area before leaving it to dry a second time. Once dried proceed to sand smooth and finish by painting to create a smooth finish.
- In the event the holes are medium-sized, purchase a small piece of drywall from the drywall supplier. Scale it so it's roughly 2 inches bigger in width and height than the size of the hole you are to cover. Keep the paper boarder intact.
- Using a utility knife or box cutter, incise the piece of drywall about one inch from either side and fracture the drywall at the incisions, to dislodge it from the main piece of drywall.
- Place the patch over the hole and draw an outline all around the piece of drywall. Then using a drywall knife, cut out the sketched square.
- Add more adhesive on the back of the paper boarder and put it on the whole patch. Press the edges of the paper until you achieve a smooth and even surface. Leave it to dry before applying the second coat if needed. You may need at least 2 coats to achieve a smooth finish.
- Finally, sand down the hard compound and paint over the area.
The Lumber Guys, is a reliable drywall supplier serving residents in the Greater Toronto. They serve contractors, builders and individuals handling the installations themselves. The company has several years of experience and strives to offer excellent quality at fair prices. Call via (647)558-9889 to request a quote.
Toronto is a bustling city with lots of construction going on all of the time. The Lumber Guys are able to provide a wide variety of materials including drywalll for just about any kind of building or renovation project that you have in mind.
Drywall is the best material to use for covering your walls. We sell drywall at reasonable prices and have a variety of products to choose from. It is available for pick up however quick and efficient delivery is also available.
By providing us a little information about your project it allows us to suggest the supplies that will be right for the job. Many people are surprised to learn that there are a variety of types of drywall available. There are types that are fire rated, as well as types that are resistant to moisture. The kind you will require will depend on the project in which it is being used.
Some examples of drywall materials and where they might be best used include:
- Regular – Ceilings
- Fire-rated – Walls
- Cement Board – Kitchens, Bathrooms
- Anti-Mold – Basements, Bathrooms
- Gyplap Sheathing – Exterior
FACTORS THAT AFFECT DRYWALL
There are two main factors that affect the different products. Size and thickness are the predominant classifications and the size you choose should be rated for the job you’re doing. Basically standard drywall thicknesses run about 3/8” to 1/2” and this is primarily used in home walls and ceilings with average stud spacing.
5/8” drywall is sometimes needed for spaces where studs are further apart or where sound deadening might be helpful. Sizes vary from 4’x8’ to those pieces that are 10’ and 12’ in length. The decision to use the bigger pieces would be determined by the number of windows, outlets and doors you need to cut around.
At The Lumber Guys, we offer all of these lengths and thicknesses with different products rated for moisture as well. And if you require advice on the proper size and thickness for your project, our experts will be happy to provide that as well.
WHY THE LUMBER GUYS?
Qualifications for your drywall material provider in Toronto should include the following three characteristics: high quality, large volume and quick delivery. We pride ourselves on being able to meet each of these three points.
And we don’t just stop at selling you drywall either. Our experts are always happy to answer any questions you may have about your product or give you tips for installation and completing your dry walling project. No matter how large or how small your project is, we understand that it is important to you and we take the time to give you any advice and assistance you may require.
At The Lumber Guys, we pride ourselves on not only offering a quality product, but also superior customer service as well. That’s why so many homeowners and contractors in the Toronto trust us for their dry walling needs. If you are searching for a drywall provider for your next project, then give us a call. We’d be happy to help you!
Painting Drywall: Doing It Correctly
As you purchase your drywall supplies, you may have thought about painting your walls once drywall is installed and ready to go. Of course, when you think painting, you might think that the job will be a walk in the park. While painting drywall is not too difficult, it is important that you follow all of the steps properly to ensure your end result is exactly what you want it to be.
Tips to Help You Finish Up Your Drywall Job
If you have never worked with drywall or drywall supplies before, you may find it difficult and frustrating to get your project done. It does take some time and practice to be able to learn how to properly apply joint compound, mix the compound, and hang the drywall. Below, we will go over some tips that will help you get through the rest of your drywall project with ease.
Check Out These Drywall Tips
Too often, homeowners start their drywall projects and then get stuck halfway through and either need to call a professional or they simply leave the job unfinished. These tips will ensure that you do not find yourself stuck in an uncertain position.
Getting Ready for Your Drywall Project
You have probably seen tons of drywall supplies at your local home improvement store and this is because drywall is one of the most common forms of interior walls within a residential home. In fact, almost all homes have some form of drywall within them and you would be hard pressed to find a home that does not.
Drywall Tools You Need for Your Upcoming Project
When it comes to your upcoming drywall project, there are some must have drywall supplies and tools you should have on hand. Below, we will go over some of the most commonly relied on tools and you can create a shopping list to head to your local home improvement store.
How to Install Ceiling Drywall
While it may seem like a difficult process, hanging ceiling drywall is easy when you have the right drywall supplies in hand. Below, we will go over the process to help give you a better idea of what you need to do and how it is done properly.
Common Drywall Mistakes to Avoid
When it comes to installing drywall, it is easy to make a mistake, especially if you do not have the right drywall supplies on hand. Below, we will go over some of the most commonly made mistakes and how to avoid them.
How to Repair Holes in Drywall
Holes happen and when they do, it helps to know how to repair them and it is even more important that you have the right drywall supplies to complete the job. Below, we will go over the easiest ways for you to repair and patch small and medium holes that may occur in your drywall.
Keep Your Drywall Free from Water Damage
Water damage can be costly, especially if you need to go out and purchase new drywall supplies to replace sections of your wall due to the damage. While you may not always be actively thinking about water damage occurring, it is important that you are proactive about watching for the signs of it and also checking common areas that are prone to leaks and flooding. Below, we will go over some of the areas you need to start checking to make sure there are no leaks.
Detecting and Preventing Water Damage to Drywall
If you notice that there is water damage to your drywall, you may need to purchase new drywall supplies and replace the section of wall that is damaged. Unfortunately, drywall can be easily damaged by water, but it helps to know how to prevent it and what to look for. Below, we will go over some tips to help you quickly identify any problems.
Tips for Simplifying Drywall Repair
Whether you’re installing drywall or trying to fix existing drywall up, you may be having some difficulties. Even if you ordered from a reliable drywall supplier, there are still things that can go wrong with the installation process. Drywall can become damaged over time as well.
Priming New Drywall Guide
After you buy drywall, install it, and finish it, it’s time to put primer and paint on. If you try to paint over fresh drywall with regular paint, it will be difficult to achieve an even finish. The only way to ensure that you will get acceptable results is by using a primer.
Guide to Installing Drywall on a Ceiling
If you’ve just placed an order with a drywall supplier and it’s for installing it on the ceiling, you’ll probably need some help. At the very least, you’ll need assistance with getting heavy sheets up against the ceiling joists. Even if it’s a typical 4×8 ft. sheet, it will still be bulky, so holding it up against the ceiling is not easy.
Getting Started with Drywall Taping
Taping drywall isn’t the easiest job in the world, but it can still be done by DIYers. If you want to take care of installation after you buy drywall, you’ll need to learn how to do taping. If you’re not careful, you will have to deal with problems such as cracks, bad joints, and nail pops later down the road.
Did You Just Buy Drywall? Here Are Tips on Securing It Properly
If you’ve just made the decision to buy drywall, you undoubtedly realize that it is a very affordable material for wall and ceiling renovation. Just because it’s inexpensive, however, doesn’t mean it’s easy to install. One area where a lot of people seem to have trouble is with fastening drywall. How do you get it to stay securely on the wall or ceiling?
Drywall Guide for Beginners
Are you looking for a drywall supplier? Working on a home project that requires drywall? You must first educate yourself about the material and what it can be used for. There are a number of factors you need to consider when buying drywall: size, layout, tools, etc.
Drywall Safety & Precaution Tips
So, you’ve just placed an order with a drywall supplier and you plan on doing all or some of the work by yourself. Be sure to put safety first. As with any construction or renovation project, there are potential dangers. You don’t want to overlook the safety aspects of drywall projects. There is a lot of lifting, screwing, cutting, sanding, and taping involved.
Drywall Patch and Repair Tips
Whenever you buy drywall, you need to accept that repairs or patching may need to be done at some point. Even if it’s installed perfectly, you never know what might happen years down the road. If you do have existing drywall that needs patched up or repaired, you must decide if you want to tackle the problem yourself or hire a professional to handle it for you.
Everything About Drywall Finishes and Textures
After you buy drywall and install it, you may want to finish it to give it a nice, decorative appearance. For some people, the perfect, smooth surface of a drywall installation isn’t enough; a finish will make it look a lot more appealing.
FAQ About Drywall
Drywall doesn’t have to be all that difficult to deal with, just as long as you have the right materials, tools, and mindset. Whether you want to buy drywall for a new project, tear down existing drywall, or do a renovation, you’ll need an understanding of the material.